Reset Breakout

Common TTL Serial to RF1/WM2999 controller compatible header.
Ship to
Shipping Method
Estimated Delivery
No shipping options

The Reset board can be used as an aid when developing or just as an adapter for your new RF1 boards to load firmware from the Arduino IDE.

It is pin compatible to most TTL Serial programmer boards and has matching pins for use on the RF1 series boards.  

When used in an upright position is also pin compatible with the WM2999 custom controller boards.  

It has a Reset button and LED to indicate when power is present.


Comes with 

1 Reset PCB and all the parts to build it.


Back in stock with new 2014 version !

Product tags
Customers who bought this item also bought

RF1 Dumb RGB Expansion board Rev2 (Board + BOM)

The Dumb RGB Expansion board adds 3 Mosfet / PWM control to your RF1_12v so you can easily control 12V RGB strips!

4 Pin Waterproof connector

These 4 pin waterproof connectors are great for connecting to the RF1 boards and getting your pixels connected!
$2.00 $1.75

nRF24L01+ 2.4 GHz RF PA With Antenna

The Nordic nRF24L01+ is a highly integrated, ultra low power (ULP) 2Mbps RF transceiver IC for the 2.4GHz ISM (Industrial, Scientific and Medical) band. With peak RX/TX currents lower than 14mA, a sub μA power down mode, advanced power management, and a 1.9 to 3.6V supply range, the nRF24L01+ provides a true ULP solution enabling months to years of battery life from coin cell or AA/AAA batteries. The Enhanced ShockBurst™ hardware protocol accelerator offloads time critical protocol functions from the application microcontroller enabling the implementation of advanced and robust wireless connectivity with low cost 3rd-party microcontrollers.