4 Pin Waterproof connector

These 4 pin waterproof connectors are great for connecting to the RF1 boards and getting your pixels connected!
Availability: On Back-order Expect 2-8 week lead time for shipping
Old price: $2.00
Ship to
Shipping Method
Estimated Delivery
No shipping options

Excellent choice for connecting your pixels to your new RF1 boards!

4 Pin waterproof pigtail for outdoor use.

Both male and female are 20 cm long each for a total of 40cm total length

.22AWG / 0.3mm²
 Note: These are much smaller in size than the other 2 and 3 pin waterproof connectors also available.
Customers who bought this item also bought

RF1 Dumb RGB Expansion board Rev2 (Board + BOM)

The Dumb RGB Expansion board adds 3 Mosfet / PWM control to your RF1_12v so you can easily control 12V RGB strips!

nRF24L01+ 2.4 GHz RF PA With Antenna

The Nordic nRF24L01+ is a highly integrated, ultra low power (ULP) 2Mbps RF transceiver IC for the 2.4GHz ISM (Industrial, Scientific and Medical) band. With peak RX/TX currents lower than 14mA, a sub μA power down mode, advanced power management, and a 1.9 to 3.6V supply range, the nRF24L01+ provides a true ULP solution enabling months to years of battery life from coin cell or AA/AAA batteries. The Enhanced ShockBurst™ hardware protocol accelerator offloads time critical protocol functions from the application microcontroller enabling the implementation of advanced and robust wireless connectivity with low cost 3rd-party microcontrollers.

Reset Breakout

Common TTL Serial to RF1/WM2999 controller compatible header.